The Challenges to Swim Spa Covers

Swim Spas represent distinct obstacles when it concerns covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same reasons a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, removing and changing the cover can be a lot more difficult.
Getting a new swim spa is an amazing occasion in life. You’re eagerly anticipating the workout you’ll get from using it. Maybe you’re a little relieved to have finally made a selection from the various designs you took a look at. At any rate, you most likely weren’t believing much about the cover you would use.
Generally, the cover that gets home with your new purchase will be a 4 section rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Till it begins to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design flaw. Integrated in obsolescence due to the fact that as soon as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are very small as they rise from the water surface area. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.

It takes place slowly and on a Swim Spa Cover which is made of specific sections, at differing speeds. So eventually you’ll observe one or two of the sections are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much help since you still need to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a new design for their Swim Spa Covers
Instead of using a number of foam panels to construct Swim Spa Covers that will eventually end up in some landfill, they designed one that uses air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or break down at the seams either. So if you own a swim spa, and you intend to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to purchase today, bookmark this website so you can discover it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *