The Challenges to Swim Spa Covers

Swim Spas represent unique obstacles when it comes to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, getting rid of and changing the cover can be a lot more difficult.
Getting a brand-new swim spa is an interesting event in life. You’re looking forward to the workout you’ll get from using it. Maybe you’re a little relieved to have finally selected from the different models you took a look at. At any rate, you probably weren’t thinking much about the cover you would use.
Usually, the cover that gets back with your new purchase will be a four section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design defect. Integrated in obsolescence since as quickly as it is put in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper will not make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are extremely small as they increase from the water surface area. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It happens gradually and on a Swim Spa Cover which is made of specific sections, at differing speeds. So ultimately you’ll see a couple of of the sections are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance due to the fact that you still have to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com came up with a new design for their Swim Spa Covers
Instead of using a number of foam panels to build Swim Spa Covers that will ultimately end up in some garbage dump, they created one that uses air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or break down at the joints either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to order today, bookmark this website so you can discover it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *